Honda CR-V (2006–2011) Service Manual

Honda CR-V (2006–2011) Service Manual

READ NEXT:

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and th

 General Information

Chassis and Paint Codes Vehicle Identification Number Manufacturer, Make and Type of Vehicle 5J6: Honda of America Mfg., Inc., U.S.A. Honda Multipurpose passenger vehicle JHL: Honda Motor Co

 Maintenance

Lubricants and Fluids For details of lubrication points and type of lubricants to be applied, refer to the illustrated index and various work procedures (such as Assembly/Reassembly, Replacement, Ove

SEE MORE:

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

 DTC P050A: Cold Start Idle Air Control System Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs other than P050A indicated? YES-Go to the indi

© 2016-2025 Copyright www.hcrv.net