Honda CR-V manuals

Honda CR-V: Engine Block

Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Block

Special Tools

Honda CR-V. Engine Block

Honda CR-V. Engine Block

  1. Oil Seal Driver Attachment, 96 mm

  2. Driver

Component Location Index

Honda CR-V. Engine Block

Honda CR-V. Engine Block

READ NEXT:

 Connecting Rod and Crankshaft End Play Inspection

1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Measure the connecting rod end play with a feeler gauge between the connecting rod and crankshaft. Connecting Rod End Play Standa

 Connecting Rod Bearing Replacement

Rod Bearing Clearance Inspection 1. Remove the oil pump. 2. Remove the baffle plates (see step 7). 3. Remove the connecting rod cap and bearing half. 4. Clean the crankshaft rod journal and bearing

 Oil Pan Removal

1. If the engine is already out of the vehicle, go to step 20. 2. Raise the vehicle on the lift to full height. 3. Drain the engine oil. 4. Remove the front wheels. 5. Remove the splash shield (se

SEE MORE:

 Front Seat

Front Seat Active Head Restraint Inspection NOTE: If the vehicle has been in a collision, always inspect the active head restraints, even if they appear reusable, by doing the following procedure. Resetting Head Restraint Position 1. Push the head restraint (A) forward fully from the locked position

 Piston Ring Replacement

1. Remove the piston from the engine block. 2. Using a ring expander (A), remove the old piston rings (B). 3. Clean all ring grooves thoroughly with a squared-off broken ring or ring groove cleaner with a blade to fit the piston grooves. The top and 2nd ring grooves are 1.2 mm (0.05 in.) wide. Th

© 2016-2026 Copyright www.hcrv.net