Honda CR-V (2006–2011) Service Manual

Honda CR-V (2006–2011) Service Manual

READ NEXT:

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and th

 General Information

Chassis and Paint Codes Vehicle Identification Number Manufacturer, Make and Type of Vehicle 5J6: Honda of America Mfg., Inc., U.S.A. Honda Multipurpose passenger vehicle JHL: Honda Motor Co

 Maintenance

Lubricants and Fluids For details of lubrication points and type of lubricants to be applied, refer to the illustrated index and various work procedures (such as Assembly/Reassembly, Replacement, Ove

SEE MORE:

 Lower Ball Joint Replacement

Special Tools Required Ball joint remover, 32 mm 07MAC-SL0A 102 Ball joint thread protector, 14 mm 071AF-S3VA000 1. Remove the front wheel. 2. Remove the flange bolt and flange nuts from the lower arm (A). NOTE: During installation, install a new flange bolt and new flange nuts. After lightly

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then turn it ON (II) again. 3. Check whether DTC P0107 is indicated in the DTCs/ Freeze Data in PGM-FI M

© 2016-2025 Copyright www.hcrv.net