Honda CR-V (2006–2011) Service Manual
Honda CR-V (2006–2011) Service Manual
- Introduction
- General Information
- Maintenance
- Engine Electrical
- Engine Mechanical
- Engine Cooling
- Fuel and Emissions
- Fuel and Emissions Systems
- PGM-FI System
- Electronic Throttle Control System
- VTEC/VTC
- Idle Control System
- Fuel Supply System
- Intake Air System
- Catalytic Converter System
- EGR System
- PCV System
- EVAP System
- Transaxle
- Steering
- Suspension
- Brakes
- Body
- Doors
- Mirrors
- Glass
- Moonroof
- Interior Trim
- Consoles
- Dashboard
- Seats
- Bumpers
- Hood
- Tailgate
- Fuel Fill Door
- Exterior Trim
- Fenderwell
- Openers
- Frame
- HVAC (Heating, Ventilation, and Air Conditioning)
- A/C Service Tips and Precautions
- System Description
- DTC Troubleshooting
- Recirculation Control Motor Circuit Troubleshooting
- Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting
- A/C Condenser Fan High Speed Circuit Troubleshooting
- A/C Signal Circuit Troubleshooting
- Blower Unit Removal/Installation
- Evaporator Core Replacement
- Heater Unit/Core Replacement
- A/C Compressor Replacement
- Receiver/Dryer Desiccant Replacement
- Body Electrical
- General Troubleshooting Information
- Relay and Control Unit Locations
- Connectors and Harnesses
- Under-hood/dash Fuse/Relay Box
- Battery
- Multiplex Integrated Control System
- Keyless/Power Door Locks/Security System
- Horns
- Exterior Lights
- Turn Signal/Hazard Flasher
- Interior Lights
- Entry Lights Control System
- Power Windows
- Wipers/Washers
- Gauges
- Reminder Systems
- Moonroof
- Accessory Power Sockets
- Power Mirrors
- Seat Heaters
- Rear Window Defogger
- Immobilizer System
- Audio, Navigation, and Telematics
- Restraints
READ NEXT:
Introduction
How to Use This Manual
This manual is divided into multiple sections. The first page of
each section is marked with a black tab that lines up with its
corresponding thumb index tab on this page and th
General Information
Chassis and Paint Codes
Vehicle Identification Number
Manufacturer, Make and Type of Vehicle
5J6: Honda of America Mfg., Inc., U.S.A.
Honda Multipurpose passenger vehicle
JHL: Honda Motor Co
Maintenance
Lubricants and Fluids
For details of lubrication points and type of lubricants to be applied, refer
to the illustrated index and various work procedures (such as
Assembly/Reassembly, Replacement, Ove
SEE MORE:
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
Evaporator Core
Replacement
1. Recover the refrigerant with a recovery/recycling/ charging station.
2. Remove the bolt from the A/C line clamp, and
remove the receiver line (A) from the clips (B).
3. Remove the nut, then disconnect the A/C lines (A)
from the evaporator core.
4. Remove the stud bolt.
5. Remove the blower un
© 2016-2025 Copyright www.hcrv.net
