Honda CR-V (2006–2011) Service Manual

Honda CR-V (2006–2011) Service Manual

READ NEXT:

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and th

 General Information

Chassis and Paint Codes Vehicle Identification Number Manufacturer, Make and Type of Vehicle 5J6: Honda of America Mfg., Inc., U.S.A. Honda Multipurpose passenger vehicle JHL: Honda Motor Co

 Maintenance

Lubricants and Fluids For details of lubrication points and type of lubricants to be applied, refer to the illustrated index and various work procedures (such as Assembly/Reassembly, Replacement, Ove

SEE MORE:

 Blower Unit Removal/Installation

1. Remove the glove box. 2. Disconnect the connector (A), then remove the connector clip (B), the wire harness clips (C), the bolts, and the glove box frame (D). 3. Cut the plastic cross brace (A) in the glove box opening with diagonal cutters in the area shown. Retain plastic cross brace to be r

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectly installed wheel bearing can cause one of these DTCs. 1. Turn the ignition switch OFF. 2. Check

© 2016-2025 Copyright www.hcrv.net