Honda CR-V (2006–2011) Service Manual
Honda CR-V (2006–2011) Service Manual
- Introduction
- General Information
- Maintenance
- Engine Electrical
- Engine Mechanical
- Engine Cooling
- Fuel and Emissions
- Fuel and Emissions Systems
- PGM-FI System
- Electronic Throttle Control System
- VTEC/VTC
- Idle Control System
- Fuel Supply System
- Intake Air System
- Catalytic Converter System
- EGR System
- PCV System
- EVAP System
- Transaxle
- Steering
- Suspension
- Brakes
- Body
- Doors
- Mirrors
- Glass
- Moonroof
- Interior Trim
- Consoles
- Dashboard
- Seats
- Bumpers
- Hood
- Tailgate
- Fuel Fill Door
- Exterior Trim
- Fenderwell
- Openers
- Frame
- HVAC (Heating, Ventilation, and Air Conditioning)
- A/C Service Tips and Precautions
- System Description
- DTC Troubleshooting
- Recirculation Control Motor Circuit Troubleshooting
- Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting
- A/C Condenser Fan High Speed Circuit Troubleshooting
- A/C Signal Circuit Troubleshooting
- Blower Unit Removal/Installation
- Evaporator Core Replacement
- Heater Unit/Core Replacement
- A/C Compressor Replacement
- Receiver/Dryer Desiccant Replacement
- Body Electrical
- General Troubleshooting Information
- Relay and Control Unit Locations
- Connectors and Harnesses
- Under-hood/dash Fuse/Relay Box
- Battery
- Multiplex Integrated Control System
- Keyless/Power Door Locks/Security System
- Horns
- Exterior Lights
- Turn Signal/Hazard Flasher
- Interior Lights
- Entry Lights Control System
- Power Windows
- Wipers/Washers
- Gauges
- Reminder Systems
- Moonroof
- Accessory Power Sockets
- Power Mirrors
- Seat Heaters
- Rear Window Defogger
- Immobilizer System
- Audio, Navigation, and Telematics
- Restraints
READ NEXT:
Introduction
How to Use This Manual
This manual is divided into multiple sections. The first page of
each section is marked with a black tab that lines up with its
corresponding thumb index tab on this page and th
General Information
Chassis and Paint Codes
Vehicle Identification Number
Manufacturer, Make and Type of Vehicle
5J6: Honda of America Mfg., Inc., U.S.A.
Honda Multipurpose passenger vehicle
JHL: Honda Motor Co
Maintenance
Lubricants and Fluids
For details of lubrication points and type of lubricants to be applied, refer
to the illustrated index and various work procedures (such as
Assembly/Reassembly, Replacement, Ove
SEE MORE:
DTC P0457: EVAP System Leak Detected/Fuel
Fill Cap Loose or Missing
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Check the fuel fill cap (the cap must say "Tighten to
click"). It should turn 1/4 turn after it's tight, then it
clicks.
Is the correct fuel fill cap installed a
Shafts and Clutches
Mainshaft Disassembly, Inspection, and Reassembly
1. Inspect the thrust needle bearing and the needle bearing for galling and
rough movement.
2. Inspect the splines for excessive wear and damage.
3. Check shaft bearing surface for scoring and excessive wear.
4. Before installing the O-rings, wra
© 2016-2025 Copyright www.hcrv.net
