Honda CR-V: Transaxle

READ NEXT:

 Automatic Transmission

Special Tools 07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100. Mainshaft Holder Attachment, 78 x 90 mm Clutch Spring Compressor Bolt Assembly Holder Handle Oil Seal Driver At

 General Troubleshooting Information

How to Check for DTCs with the Honda Diagnostic System (HDS) When the powertrain control module (PCM) senses an abnormality in the input or output system, the D indicator (A) in the gauge control modu

 System Description

SEE MORE:

 To Remove Exterior Frost or Ice Fromthe Windows

1. Select . The system automatically switches to fresh air mode and turns on the A/C. The A/C indicator does not come on if it was off to start with. 2. Select . 3. Set the fan and temperature controls to maximum level. To clear the windows faster, you can close the dashboard corner

 Receiver/Dryer Desiccant Replacement

NOTE: Install the receiver/dryer as quickly as possible to prevent the system from absorbing moisture from the air. 1. Remove the A/C condenser. 2. Remove the cap (A) from the bottom of the A/C condenser. Remove the O-ring (B) and the desiccant (C). 3. Install the receiver/dryer in the reverse or

© 2016-2025 Copyright www.hcrv.net