Honda CR-V: Transaxle

READ NEXT:

 Automatic Transmission

Special Tools 07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100. Mainshaft Holder Attachment, 78 x 90 mm Clutch Spring Compressor Bolt Assembly Holder Handle Oil Seal Driver At

 General Troubleshooting Information

How to Check for DTCs with the Honda Diagnostic System (HDS) When the powertrain control module (PCM) senses an abnormality in the input or output system, the D indicator (A) in the gauge control modu

 System Description

SEE MORE:

 VTC Oil Control Solenoid Valve Removal/Test/Installation

1. Disconnect the VTC oil control solenoid valve 2P connector (A). 2. Remove the bolt (B) and the VTC oil control solenoid valve (C). 3. Check the VTC oil control solenoid valve strainer for clogging. If the strainer is clogged, replace the VTC oil control solenoid valve. 4. Note the amount of va

 Symptom Troubleshooting

VSA activation indicator does not go off, and no DTCs are stored 1. Turn the ignition switch ON (II), and watch the VSA activation indicator. Does VSA activation indicator go off within 2 seconds? YES-The system is OK at this time. NO-Go to step 2. 2. Turn the ignition switch OFF. 3. Disconnect

© 2016-2025 Copyright www.hcrv.net