Honda CR-V: Transaxle

READ NEXT:

 Automatic Transmission

Special Tools 07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100. Mainshaft Holder Attachment, 78 x 90 mm Clutch Spring Compressor Bolt Assembly Holder Handle Oil Seal Driver At

 General Troubleshooting Information

How to Check for DTCs with the Honda Diagnostic System (HDS) When the powertrain control module (PCM) senses an abnormality in the input or output system, the D indicator (A) in the gauge control modu

 System Description

SEE MORE:

 Injector Replacement

1. Relieve fuel pressure. 2. Remove the engine cover. 3. Disconnect the connectors (A) from the injectors. 4. Remove the ground cable bolt (G101) (B). 5. Disconnect the quick-connect fitting (C). 6. Remove the fuel rail mounting nuts (D) from the fuel rail (E). 7. Remove the injector clip (F)

 Valve Clearance Adjustment

Special Tools Required Adjuster 07MAA-PR70110 Locknut wrench 07MAA-PR70120 NOTE: Adjust the valves only when the cylinder head temperature is less than 100 ºF (38 ºC). 1. Remove the cylinder head cover. 2. Set the No.1 piston at top dead center (TDC). The punch mark (A) on the variable valve

© 2016-2025 Copyright www.hcrv.net