Honda CR-V: Body Electrical

READ NEXT:

 General Troubleshooting Information

Tips and Precautions Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and clean and tight connections. NOTICE Do

 Relay and Control Unit Locations

Engine Compartment VSA MODULATOR-CONTROL UNIT AUXILIARY UNDER-HOOD RELAY BOX POWER MIRROR DEFOGGER RELAY PCM RADIATOR FAN RELAY ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY ELD U

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals

SEE MORE:

 Checking and Replacing Fuses

If something electrical in your vehicle stops working, check for a blown fuse first. Determine from the chart on pages, or the diagram on the fuse box lid, which fuse or fuses control that device. Check those fuses first, but check all the fuses before deciding that a blown fuse is th

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

© 2016-2025 Copyright www.hcrv.net