Honda CR-V: Body Electrical
Honda CR-V (2006–2011) Service Manual / Body Electrical
- General Troubleshooting Information
- Relay and Control Unit Locations
- Connectors and Harnesses
- Under-hood/dash Fuse/Relay Box
- Battery
- Multiplex Integrated Control System
- Keyless/Power Door Locks/Security System
- Horns
- Exterior Lights
- Turn Signal/Hazard Flasher
- Interior Lights
- Entry Lights Control System
- Power Windows
- Wipers/Washers
- Gauges
- Reminder Systems
- Moonroof
- Accessory Power Sockets
- Power Mirrors
- Seat Heaters
- Rear Window Defogger
- Immobilizer System
READ NEXT:
General Troubleshooting Information
Tips and Precautions
Before Troubleshooting
1. Check applicable fuses in the appropriate fuse/relay
box.
2. Check the battery for damage, state of charge, and
clean and tight connections.
NOTICE
Do
Relay and Control Unit
Locations
Engine Compartment
VSA MODULATOR-CONTROL UNIT
AUXILIARY UNDER-HOOD
RELAY BOX
POWER MIRROR
DEFOGGER RELAY
PCM
RADIATOR FAN RELAY
ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY
ELD U
Connectors and Harnesses
Connector Index
Identification numbers have been assigned to in-line connectors, junction
connectors, and terminals. The number is preceded by the letter ºC" for
connectors "G" for ground terminals
SEE MORE:
VSA (Vehicle Stability Assist) System Components
Component Location Index
VSA MODULATOR-CONTROL UNIT
Removal and Installation
UNDER-HOOD FUSE/RELAY BOX
DATA LINK
CONNECTOR (DLC)
STEERING ANGLE SENSOR
Replacement
VSA OFF SWITCH
Test
RIGHT-REAR WHEEL SENSOR
Replacement
HUB BEARING UNIT
(MAGNETIC ENCODER)
Replace
Piston Ring Replacement
1. Remove the piston from the engine block.
2. Using a ring expander (A), remove the old piston
rings (B).
3. Clean all ring grooves thoroughly with a squared-off
broken ring or ring groove cleaner with a blade
to fit the piston grooves.
The top and 2nd ring grooves are 1.2 mm (0.05 in.)
wide. Th
© 2016-2025 Copyright www.hcrv.net
