Honda CR-V: Body Electrical

READ NEXT:

 General Troubleshooting Information

Tips and Precautions Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and clean and tight connections. NOTICE Do

 Relay and Control Unit Locations

Engine Compartment VSA MODULATOR-CONTROL UNIT AUXILIARY UNDER-HOOD RELAY BOX POWER MIRROR DEFOGGER RELAY PCM RADIATOR FAN RELAY ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY ELD U

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals

SEE MORE:

 Ignition System

Component Location Index SPARK PLUG Inspection IGNITION COIL Ignition Timing Inspection Removal/Installation Circuit Diagram Ignition Timing Inspection 1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC). 2. Turn the ignition switch

 Introduction

Congratulations! Your selection of a 2010 Honda CR-V was a wise investment. It will give you years of driving pleasure. One of the best ways to enhance the enjoyment of your new vehicle is to read this manual. In it, you will learn how to operate its driving controls and convenience items. Af

© 2016-2025 Copyright www.hcrv.net