Honda CR-V: Engine Mechanical

READ NEXT:

 Engine Assembly

 Engine Removal

Universal eyelet 07AAK-SNAA120 Engine hanger adapter VSB02C000015 * Front subframe adapter VSB02C000016 * CR-V engine hanger adapter VSB02C000032 * Engine support hanger, A and Reds AAR-T-12566

 Engine Installation

Special Tools Required Universal eyelet 07 AAK-SNAA 120 Engine hanger adapter VSB02C000015 * Front subframe adapter VSB02C000016 * CR-V engine hanger adapter VSB02C000032 * Engine support hanger

SEE MORE:

 DTC P0457: EVAP System Leak Detected/Fuel Fill Cap Loose or Missing

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check the fuel fill cap (the cap must say "Tighten to click"). It should turn 1/4 turn after it's tight, then it clicks. Is the correct fuel fill cap installed a

 Dual Pump System Function Test

Starting and accelerating in forward gears (4WD mode) NOTE: Do not test repeatedly or the fluid will overheat. 1. Lift up the vehicle so all four wheels are off the ground. 2. Make a mark (A) on either No.1 or No.2 propeller shaft (B). 3. Start the engine, and let it run until it warms up (the ra

© 2016-2025 Copyright www.hcrv.net