Honda CR-V: Body
- Doors
- Mirrors
- Glass
- Moonroof
- Interior Trim
- Consoles
- Dashboard
- Center Upper Dashboard Panel Removal/Installation
- Driver's Vent Panel Removal/Installation
- Passenger's Tray Removal/Installation
- Glove Box Removal/Installation
- Column Cover Removal/Installation
- Seats
- Bumpers
- Hood
- Tailgate
- Fuel Fill Door
- Exterior Trim
- Upper/Lower Front Grille Replacement
- Cowl Cover Replacement
- Door Lower Trim Replacement
- Side Windshield Trim Replacement
- Fenderwell
- Openers
- Frame
READ NEXT:
Doors
Component Location Index-Front Door
DOOR CENTER OUTER TRIM
DOOR LINING BRACKETS
DOOR OUTER MOLDING
Replacement
DOOR GLASS OUTER
WEATHERSTRIP
Replacement
HINGE
DOOR CHECKER
DOOR
Front Door
Front Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Ameri
Rear Door
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Americ
SEE MORE:
Rear Driveshaft
Rear Driveshaft Removal
1. Raise the vehicle on a lift, and remove the rear
wheels.
2. Lift up the locking tab (A) on the spindle nut (B),
then remove the nut.
3. Drain the differential fluid.
4. Remove the rear driveshaft inboard joint from the rear differential assembly.
5. Disconnect the rear
Reminder Systems
Component Location Index
GAUGE CONTROL MODULE
MICU
Circuit Diagram
Control Unit Input Test
NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.
MICU
1. Turn the ignition switch OFF.
2. Remove the left kick panel.
3. Disconnect the under-dash fuse/relay box connectors.
© 2016-2026 Copyright www.hcrv.net
