Honda CR-V: Body

READ NEXT:

 Doors

Component Location Index-Front Door DOOR CENTER OUTER TRIM DOOR LINING BRACKETS DOOR OUTER MOLDING Replacement DOOR GLASS OUTER WEATHERSTRIP Replacement HINGE DOOR CHECKER DOOR

 Front Door

Front Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the Ameri

 Rear Door

Rear Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the Americ

SEE MORE:

 Fuel Fill Door

Fuel Fill Door Adjustment 1. Remove the nut (A), then remove the open spring (B). 2. Slightly loosen the hinge mounting bolts (A). 3. Adjust the fuel fill door (B) in or out until it's flush with the body, and up or down as necessary to equalize the gaps. 4. Tighten the hinge mounting bolts. 5. C

 Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting

NOTE: Do not use this troubleshooting procedure if the A/C compressor is inoperative. Refer to the symptom troubleshooting index. Before doing symptom troubleshooting, check for powertrain DTCs. 1. Check the No.7 (20 A) fuse in the under-hood fuse/relay box, and the No. 36 (10 A) fuse in the

© 2016-2025 Copyright www.hcrv.net