Honda CR-V: Body

READ NEXT:

 Doors

Component Location Index-Front Door DOOR CENTER OUTER TRIM DOOR LINING BRACKETS DOOR OUTER MOLDING Replacement DOOR GLASS OUTER WEATHERSTRIP Replacement HINGE DOOR CHECKER DOOR

 Front Door

Front Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the Ameri

 Rear Door

Rear Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the Americ

SEE MORE:

 Evaporator Core Replacement

1. Recover the refrigerant with a recovery/recycling/ charging station. 2. Remove the bolt from the A/C line clamp, and remove the receiver line (A) from the clips (B). 3. Remove the nut, then disconnect the A/C lines (A) from the evaporator core. 4. Remove the stud bolt. 5. Remove the blower un

 A/C Signal Circuit Troubleshooting

NOTE: Use this troubleshooting procedure if the A/C compressor, the A/C condenser fan, and radiator fan are inoperative. Before doing symptom troubleshooting, check for and resolve any powertrain DTCs. 1. Turn the ignition switch ON (II). 2. Check if the blower motor operates at all speeds.

© 2016-2026 Copyright www.hcrv.net