Honda CR-V: Fuel and Emissions
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions
- Fuel and Emissions Systems
- PGM-FI System
- DTC Troubleshooting
- F-CAN Circuit Troubleshooting
- DLC Circuit Troubleshooting
- Injector Replacement
- PCM Replacement
- Electronic Throttle Control System
- VTEC/VTC
- Idle Control System
- DTC Troubleshooting
- A/C Signal Circuit Troubleshooting
- PSP Switch Signal Circuit Troubleshooting
- Brake Pedal Position Switch Signal Circuit Troubleshooting
- Fuel Supply System
- Intake Air System
- Catalytic Converter System
- EGR System
- PCV System
- EVAP System
READ NEXT:
Fuel and Emissions Systems
Special Tools
Fuel Sender Wrench
Fuel Pressure Gauge Attachment Set
Vacuum/Pressure Gauge, 0-4 in.Hg
Pressure Gauge Adapter
Oil Pressure Hose
A/T Pressure Hose
A/T Low Pressure
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
System Description
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor
SEE MORE:
Recommended Tire Pressures
]The following chart shows the
recommended cold tire pressures for
most normal and high-speed driving
conditions.
Tire Size
Cold Tire Pressure for Normal Driving
225/65R17 102T
Front/Rear: 30 psi (210 kPa , 2.1 kgf/cm2 )
The compact spare tire pressure is:
60 psi
DTC Troubleshooting
DTC P0461: Fuel Level Sensor (Fuel Gauge
Sending Unit) Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
Because it requires 162 miles (260 km) of driving
without refueling to complete
© 2016-2025 Copyright www.hcrv.net
