Honda CR-V: Fuel and Emissions
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions
- Fuel and Emissions Systems
- PGM-FI System
- DTC Troubleshooting
- F-CAN Circuit Troubleshooting
- DLC Circuit Troubleshooting
- Injector Replacement
- PCM Replacement
- Electronic Throttle Control System
- VTEC/VTC
- Idle Control System
- DTC Troubleshooting
- A/C Signal Circuit Troubleshooting
- PSP Switch Signal Circuit Troubleshooting
- Brake Pedal Position Switch Signal Circuit Troubleshooting
- Fuel Supply System
- Intake Air System
- Catalytic Converter System
- EGR System
- PCV System
- EVAP System
READ NEXT:
Fuel and Emissions Systems
Special Tools
Fuel Sender Wrench
Fuel Pressure Gauge Attachment Set
Vacuum/Pressure Gauge, 0-4 in.Hg
Pressure Gauge Adapter
Oil Pressure Hose
A/T Pressure Hose
A/T Low Pressure
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
System Description
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor
SEE MORE:
Compact Spare Tire
Use the compact spare tire as a
temporary replacement only. Get
your regular tire repaired or replaced,
and put it back on your vehicle as
soon as you can.
Check the air pressure of the
compact spare tire every time you
check the other tires. It should be
inflated to:
60 psi (420 kPa
Crankshaft Installation
Special Tools Required
Driver 077 49-00 10000
Oil seal driver attachment, 96 mm 07ZAD-PNAA.100
1. Check the connecting rod bearing clearance with
plastigage.
2. Check the main bearing clearance with plastigage.
3. Install the bearing halves in the engine block and
connecting rods.
4. Apply a
© 2016-2025 Copyright www.hcrv.net
