Honda CR-V: Fuel and Emissions
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions
- Fuel and Emissions Systems
- PGM-FI System
- DTC Troubleshooting
- F-CAN Circuit Troubleshooting
- DLC Circuit Troubleshooting
- Injector Replacement
- PCM Replacement
- Electronic Throttle Control System
- VTEC/VTC
- Idle Control System
- DTC Troubleshooting
- A/C Signal Circuit Troubleshooting
- PSP Switch Signal Circuit Troubleshooting
- Brake Pedal Position Switch Signal Circuit Troubleshooting
- Fuel Supply System
- Intake Air System
- Catalytic Converter System
- EGR System
- PCV System
- EVAP System
READ NEXT:
Fuel and Emissions Systems
Special Tools
Fuel Sender Wrench
Fuel Pressure Gauge Attachment Set
Vacuum/Pressure Gauge, 0-4 in.Hg
Pressure Gauge Adapter
Oil Pressure Hose
A/T Pressure Hose
A/T Low Pressure
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
System Description
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor
SEE MORE:
Symptom Troubleshooting
Low pressure indicator does not come on,
and no DTCs are stored
1. Turn the ignition switch ON (II).
2. Check the low pressure indicator for several
seconds when the ignition switch is turned ON (II).
Did the indicator come on and then go off?
YES-Go to step 3.
NO-Go to step 8.
3. Turn the ignit
Heater Unit/Core
Replacement
SRS components are located in this area. Review the
SRS component locations, and the
precautions and procedures before
doing repairs or service.
1. Make sure you have anti-theft codes for the audio
system and the navigation system (if equipped).
2. Make sure the ignition is OFF, then disconnect the
© 2016-2026 Copyright www.hcrv.net
