Honda CR-V: Fuel and Emissions
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions
- Fuel and Emissions Systems
- PGM-FI System
- DTC Troubleshooting
- F-CAN Circuit Troubleshooting
- DLC Circuit Troubleshooting
- Injector Replacement
- PCM Replacement
- Electronic Throttle Control System
- VTEC/VTC
- Idle Control System
- DTC Troubleshooting
- A/C Signal Circuit Troubleshooting
- PSP Switch Signal Circuit Troubleshooting
- Brake Pedal Position Switch Signal Circuit Troubleshooting
- Fuel Supply System
- Intake Air System
- Catalytic Converter System
- EGR System
- PCV System
- EVAP System
READ NEXT:
Fuel and Emissions Systems
Special Tools
Fuel Sender Wrench
Fuel Pressure Gauge Attachment Set
Vacuum/Pressure Gauge, 0-4 in.Hg
Pressure Gauge Adapter
Oil Pressure Hose
A/T Pressure Hose
A/T Low Pressure
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
System Description
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor
SEE MORE:
PCM Replacement
NOTE:
Make sure the HDS is loaded with the latest software
version.
If you are replacing the PCM after substituting a
known-good PCM, reinstall the original PCM, then do
this procedure.
During the procedure, is any READ DATA, WRITE
DATA, or other data checks fail, note the failure, then
con
DTC P0731: Problem in 1st Clutch and 1st
Clutch Hydraulic Circuit
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the
proper level, and check for fluid
© 2016-2025 Copyright www.hcrv.net
