Honda CR-V: Automatic Transmission

Special Tools

Honda CR-V. Automatic Transmission

07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100.

Honda CR-V. Automatic Transmission

  1. Mainshaft Holder
  2. Attachment, 78 x 90 mm
  3. Clutch Spring Compressor Bolt Assembly
  4. Holder Handle
  5. Oil Seal Driver Attachment
  6. Attachment, 40 x 50 mm
  7. Clutch spring Compressor Attachment
  8. Bearing Installer Attachment
  9. Installer Shaft
  10. A/T Pressure Hose, 2,210 mm
  11. A/T Pressure Hose Adapter
  12. Attachment, 78 x 80 mm
  13. Attachment, 42 mm I.D.
  14. Companion Flange Holder
  15. Clutch Compressor Attachment
  16. Tapered Bearing Outer Race Attachment
  17. Preload Inspection Tool
  18. A/T Clutch Pressure Gauge Set/Panel
  19. Adjustable Bearing Puller, 25-40 mm

Honda CR-V. Automatic Transmission

07736-A01000B or 07736-A01000A must be used with commercially available 3/8 "-16 slide hammer.

Honda CR-V. Automatic Transmission

  1. Attachment, 32 x 35 mm
  2. Attachment, 42 x 47 mm
  3. Attachment, 52 x 55 mm
  4. Attachment, 62 x 68 mm
  5. Attachment, 72 x 75 mm
  6. Attachment, 22 x 24 mm
  7. Attachment, 40 x 42 mm
  8. Driver, 40 mm 1.0.
  9. Attachment, 35 mm 1.0.
  10. Driver
  11. Oil Seal Driver Attachment
  12. Oil Seal Driver Attachment

READ NEXT:

 General Troubleshooting Information

How to Check for DTCs with the Honda Diagnostic System (HDS) When the powertrain control module (PCM) senses an abnormality in the input or output system, the D indicator (A) in the gauge control modu

 System Description

 General Operation

The automatic transmission is a combination of a 3-element torque converter and triple-shaft electronically controlled unit which provides 5 speeds forward and 1 reverse. The entire unit is position

SEE MORE:

 Carrying Cargo

Your vehicle has several convenient storage areas: Lower glove box Upper glove box Console compartment Door pockets Seat-back pockets Seat-under tray (if equipped) Center pocket Cargo area, including the rear seats when folded up or down. Upper and lower cargo areas with the dual deck c

 Symptom Troubleshooting

VSA activation indicator does not go off, and no DTCs are stored 1. Turn the ignition switch ON (II), and watch the VSA activation indicator. Does VSA activation indicator go off within 2 seconds? YES-The system is OK at this time. NO-Go to step 2. 2. Turn the ignition switch OFF. 3. Disconnect

© 2016-2025 Copyright www.hcrv.net