Honda CR-V: Automatic Transmission

Special Tools

Honda CR-V. Automatic Transmission

07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100.

Honda CR-V. Automatic Transmission

  1. Mainshaft Holder
  2. Attachment, 78 x 90 mm
  3. Clutch Spring Compressor Bolt Assembly
  4. Holder Handle
  5. Oil Seal Driver Attachment
  6. Attachment, 40 x 50 mm
  7. Clutch spring Compressor Attachment
  8. Bearing Installer Attachment
  9. Installer Shaft
  10. A/T Pressure Hose, 2,210 mm
  11. A/T Pressure Hose Adapter
  12. Attachment, 78 x 80 mm
  13. Attachment, 42 mm I.D.
  14. Companion Flange Holder
  15. Clutch Compressor Attachment
  16. Tapered Bearing Outer Race Attachment
  17. Preload Inspection Tool
  18. A/T Clutch Pressure Gauge Set/Panel
  19. Adjustable Bearing Puller, 25-40 mm

Honda CR-V. Automatic Transmission

07736-A01000B or 07736-A01000A must be used with commercially available 3/8 "-16 slide hammer.

Honda CR-V. Automatic Transmission

  1. Attachment, 32 x 35 mm
  2. Attachment, 42 x 47 mm
  3. Attachment, 52 x 55 mm
  4. Attachment, 62 x 68 mm
  5. Attachment, 72 x 75 mm
  6. Attachment, 22 x 24 mm
  7. Attachment, 40 x 42 mm
  8. Driver, 40 mm 1.0.
  9. Attachment, 35 mm 1.0.
  10. Driver
  11. Oil Seal Driver Attachment
  12. Oil Seal Driver Attachment

READ NEXT:

 General Troubleshooting Information

How to Check for DTCs with the Honda Diagnostic System (HDS) When the powertrain control module (PCM) senses an abnormality in the input or output system, the D indicator (A) in the gauge control modu

 System Description

 General Operation

The automatic transmission is a combination of a 3-element torque converter and triple-shaft electronically controlled unit which provides 5 speeds forward and 1 reverse. The entire unit is position

SEE MORE:

 DTC 83-26: No Signal From the Front Passenger's Weight Sensor (rear outer side)

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Read the DTC. Is DTC 83-26 indicated? YES-Go to step 3. NO-Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. 3. From INSPECTION m

 DTC P0455/P0456: EVAP System Large Leak Detected/Very Small Leak Detected

DTC P0455: EVAP System Large Leak Detected DTC P0456: EVAP System Very Small Leak Detected NOTICE The fuel system is designed to allow specified maximum vacuum and pressure conditions. Do not deviate from the vacuum and pressure tests as indicated in these procedures. Excessive pressure/ vacuum wou

© 2016-2025 Copyright www.hcrv.net