Honda CR-V: Suspension

READ NEXT:

 Front and Rear Suspension

Special Tools Strut Nut Adapter Universal Eyelet Hub Dis/Assembly Tool Attachment, 40 mm Ball Joint Remover, 32 mm Ball Joint Remover, 28 mm Ball Joint Thread Protector, 14 mm Attachment, 72

 Front Suspension

 Knuckle/Hub/Wheel Bearing Replacement

Exploded View Special Tools Required Hub dis/assembly tool 07GAF-SD40100 Ball joint remover, 32 mm 07MAC-SL0A102 Ball joint remover, 28 mm 07MAC-SL0A202 Ball joint thread protector, 14 mm 071AF-

SEE MORE:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

 Potential Vehicle Hazards

Carbon Monoxide poison from engine exhaust. Be sure there is adequate ventilation whenever you operate the engine. Burns from hot parts. Let the engine and exhaust system cool down before touching any parts. Injury from moving parts. Do not run the engine unless instructed to do so.

© 2016-2025 Copyright www.hcrv.net