Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0101: MAF Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P1128, P1129, P2228, and/or P2229 are stored at the sa

 DTC P0111: IAT Sensor Circuit Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check for poor connections or loose terminals at ECT sensor 1/2

 DTC P0116: ECT Sensor 1 Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Check ECT SENSOR 1 in the

SEE MORE:

 Sleep and Wake-up Mode Test

1. Shift to the sleep mode: Turn the ignition switch OFF, and remove the key. If the MICU receives no signals from the inputs listed below, it will go into sleep mode in less than 40 seconds. Driver's door lock switch (LOCK or UNLOCK) Driver's door key cylinder switch (LOCK or UNLOCK) Front pas

 Accessories

Your dealer has Honda accessories that allow you to personalize your vehicle. These accessories have been designed and approved for your vehicle, and are covered by warranty. Although non-Honda accessories may fit on your vehicle, they may not meet factory specifications, and could ad

© 2016-2025 Copyright www.hcrv.net