Honda CR-V: Suspension

READ NEXT:

 Front and Rear Suspension

Special Tools Strut Nut Adapter Universal Eyelet Hub Dis/Assembly Tool Attachment, 40 mm Ball Joint Remover, 32 mm Ball Joint Remover, 28 mm Ball Joint Thread Protector, 14 mm Attachment, 72

 Front Suspension

 Knuckle/Hub/Wheel Bearing Replacement

Exploded View Special Tools Required Hub dis/assembly tool 07GAF-SD40100 Ball joint remover, 32 mm 07MAC-SL0A102 Ball joint remover, 28 mm 07MAC-SL0A202 Ball joint thread protector, 14 mm 071AF-

SEE MORE:

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then turn it ON (II) again. 3. Check whether DTC P0107 is indicated in the DTCs/ Freeze Data in PGM-FI M

 Parking Brake

Parking Brake Inspection CAUTION Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health. Avoid breathing dust particles. Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner. 1. Raise the rear of

© 2016-2025 Copyright www.hcrv.net