Honda CR-V: Driving
Honda CR-V (2006–2011) Owner's Manual / Driving
This section gives you tips on starting the engine under various conditions, and how to operate the automatic transmission. It also includes important information on parking your vehicle, the braking system, the vehicle stability assist (VSA ) system, the tire pressure monitoring system (TPMS), and facts you need if you are planning to tow a trailer or drive off-highway.
- Driving Guidelines
- Preparing to Drive
- Starting the Engine
- Automatic Transmission
- Parking
- Braking System
- Anti-lock Brakes (ABS)
- Vehicle Stability Assist (VSA ), aka Electronic Stability Control (ESC), System
- Tire Pressure Monitoring System (TPMS)
- Towing a Trailer
- Load Limits
- Checking Loads
- Towing Equipment and Accessories
- Pre-Tow Checklist
- Driving Safely With a Trailer
- Towing Your Vehicle Behind a Motorhome
- Off-Highway Driving Guidelines
READ NEXT:
Driving Guidelines
Your vehicle has higher ground
clearance that allows you to travel
over bumps, obstacles, and rough
terrain. It also provides good
visibility so you can anticipate
problems earlier.
Because
Preparing to Drive
You still need to exercise the same
care when accelerating, steering, and
braking that you would in a twowheel
drive vehicle.
1. Make sure all windows, mirrors,
and outside lights are clean a
Starting the Engine
1. Apply the parking brake.
2. In cold weather, turn off all
electrical accessories to reduce
the drain on the battery.
3. Make sure the shift lever is in
Park. Press on the brake pedal.
4. W
SEE MORE:
Rear Door
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Use the appropriate tool from the KTC
Blower Unit
Removal/Installation
1. Remove the glove box.
2. Disconnect the connector (A), then remove the
connector clip (B), the wire harness clips (C), the
bolts, and the glove box frame (D).
3. Cut the plastic cross brace (A) in the glove box
opening with diagonal cutters in the area shown.
Retain plastic cross brace to be r
© 2016-2025 Copyright www.hcrv.net
