Honda CR-V manuals

Honda CR-V: Off-Highway Driving Guidelines

Honda CR-V (2006–2011) Owner's Manual / Driving / Off-Highway Driving Guidelines

READ NEXT:

 General Information

Your vehicle has been designed primarily for use on pavement. But its higher ground clearance allows you to occasionally travel on unpaved roads, such as campgrounds, picnic sites, and simil

 Important Safety Precautions

To avoid loss of control or rollover, be sure to follow all precautions and recommendations. Be sure to store cargo properly and do not exceed your cargo load limits. Wherever you drive, mak

 Check Out Your Vehicle

Before you leave the pavement, be sure to do all scheduled maintenance and service, and inspect your vehicle for any problems. Pay special attention to the condition of the tires, and check

SEE MORE:

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot. N

© 2016-2026 Copyright www.hcrv.net