Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0101: MAF Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P1128, P1129, P2228, and/or P2229 are stored at the sa

 DTC P0111: IAT Sensor Circuit Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check for poor connections or loose terminals at ECT sensor 1/2

 DTC P0116: ECT Sensor 1 Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Check ECT SENSOR 1 in the

SEE MORE:

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

 HVAC (Heating, Ventilation, and Air Conditioning)

Special Tools Backprobe set Component Location Index SERVICE VALVE (HIGH-PRESSURE SIDE) SERVICE VALVE (LOW-PRESSURE SIDE) EVAPORATOR CORE (Located-in the heater unit) RECEIVER/DRYER DESICCANT Replacement A/C CONDENSER Replacement Clutch Check Clutch Overhaul Thermal Prote

© 2016-2025 Copyright www.hcrv.net