Honda CR-V: DTC Troubleshooting
- DTC P0101: MAF Sensor Range/Performance Problem
- DTC P0111: IAT Sensor Circuit Range/Performance Problem
- DTC P0116: ECT Sensor 1 Range/Performance Problem
- DTC P0128: Cooling System Malfunction
- DTC P0137: Secondary HO2S (Sensor 2) Circuit Low Voltage
- DTC P0300: Random Misfire and Any Combination of the Following
- DTC P0325: Knock Sensor Circuit Malfunction
- DTC P0335: CKP Sensor No Signal
- DTC P050A: Cold Start Idle Air Control System Performance Problem
- DTC P1116: ECT Sensor 1 Performance Problem
- DTC P1157: A/F Sensor (Sensor 1) AFS Circuit High Voltage
- DTC P1549: Charging System High Voltage
- DTC P2227: BARD Sensor Range/Performance Problem
- DTC P2270/P2271: Secondary HO2S (Sensor 2) Circuit Signal Stuck Lean/Rich
- DTC U0028: F-CAN Malfunction (BUS-OFF (PCM) )
READ NEXT:
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
DTC P0111: IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
DTC P0116: ECT Sensor 1 Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Check ECT SENSOR 1 in the
SEE MORE:
Oil Pump Overhaul
Exploded View
Oil Pump Removal
1. Turn the crankshaft pulley so its top dead center
(TDC) mark (A) lines up with the pointer (B).
2. Remove the oil pan.
3. Remove and discard the oil pump chain tensioner.
4. To hold the rear balancer shaft, insert a 6 mm pin
driver (A) into the maintenance hole
Ignition System
Component Location Index
SPARK PLUG
Inspection
IGNITION COIL
Ignition Timing Inspection
Removal/Installation
Circuit Diagram
Ignition Timing Inspection
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC).
2. Turn the ignition switch
© 2016-2025 Copyright www.hcrv.net
