Honda CR-V: DTC Troubleshooting
- DTC P0101: MAF Sensor Range/Performance Problem
- DTC P0111: IAT Sensor Circuit Range/Performance Problem
- DTC P0116: ECT Sensor 1 Range/Performance Problem
- DTC P0128: Cooling System Malfunction
- DTC P0137: Secondary HO2S (Sensor 2) Circuit Low Voltage
- DTC P0300: Random Misfire and Any Combination of the Following
- DTC P0325: Knock Sensor Circuit Malfunction
- DTC P0335: CKP Sensor No Signal
- DTC P050A: Cold Start Idle Air Control System Performance Problem
- DTC P1116: ECT Sensor 1 Performance Problem
- DTC P1157: A/F Sensor (Sensor 1) AFS Circuit High Voltage
- DTC P1549: Charging System High Voltage
- DTC P2227: BARD Sensor Range/Performance Problem
- DTC P2270/P2271: Secondary HO2S (Sensor 2) Circuit Signal Stuck Lean/Rich
- DTC U0028: F-CAN Malfunction (BUS-OFF (PCM) )
READ NEXT:
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
DTC P0111: IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
DTC P0116: ECT Sensor 1 Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Check ECT SENSOR 1 in the
SEE MORE:
Multiplex Integrated Control System
Component Location Index
GAUGE CONTROL MODULE
Input Test
Replacement
IMMOBILIZER-KEYLESS CONTROL UNIT
(Built in receiver)
MICU (Built into the under-dash fuse/relay box)
Input Test
Replacement
General Troubleshooting Information
Troubleshooting CAN Circuit Related Problems
NOT
VTC Oil Control Solenoid Valve Removal/Test/Installation
1. Disconnect the VTC oil control solenoid valve 2P
connector (A).
2. Remove the bolt (B) and the VTC oil control
solenoid valve (C).
3. Check the VTC oil control solenoid valve strainer
for clogging. If the strainer is clogged, replace the
VTC oil control solenoid valve.
4. Note the amount of va
© 2016-2025 Copyright www.hcrv.net
