Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0101: MAF Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P1128, P1129, P2228, and/or P2229 are stored at the sa

 DTC P0111: IAT Sensor Circuit Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check for poor connections or loose terminals at ECT sensor 1/2

 DTC P0116: ECT Sensor 1 Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Check ECT SENSOR 1 in the

SEE MORE:

 Driver's Airbag Replacement

Removal 1. Disconnect the negative cable from the battery and wait at least 3 minutes before beginning work. 2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) and horn switch 1P connector (C) from the cable reel. 3. Using a TORX T30 bit, r

 Changing a Flat Tire

If you have a flat tire while driving, stop in a safe place to change it. Drive slowly along the shoulder until you get to an exit or an area to stop that is far away from the traffic lanes. The vehicle can easily roll off the jack, seriously injuring anyone underneath. Follow the d

© 2016-2025 Copyright www.hcrv.net