Honda CR-V: DTC Troubleshooting
- DTC P0101: MAF Sensor Range/Performance Problem
- DTC P0111: IAT Sensor Circuit Range/Performance Problem
- DTC P0116: ECT Sensor 1 Range/Performance Problem
- DTC P0128: Cooling System Malfunction
- DTC P0137: Secondary HO2S (Sensor 2) Circuit Low Voltage
- DTC P0300: Random Misfire and Any Combination of the Following
- DTC P0325: Knock Sensor Circuit Malfunction
- DTC P0335: CKP Sensor No Signal
- DTC P050A: Cold Start Idle Air Control System Performance Problem
- DTC P1116: ECT Sensor 1 Performance Problem
- DTC P1157: A/F Sensor (Sensor 1) AFS Circuit High Voltage
- DTC P1549: Charging System High Voltage
- DTC P2227: BARD Sensor Range/Performance Problem
- DTC P2270/P2271: Secondary HO2S (Sensor 2) Circuit Signal Stuck Lean/Rich
- DTC U0028: F-CAN Malfunction (BUS-OFF (PCM) )
READ NEXT:
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
DTC P0111: IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
DTC P0116: ECT Sensor 1 Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Check ECT SENSOR 1 in the
SEE MORE:
DTC P0705: Short in Transmission Range
Switch Circuit (Multiple Shift-Position Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Clear the DTC with the HDS.
2. Start the
Checking and Replacing Fuses
If something electrical in your
vehicle stops working, check for a
blown fuse first. Determine from the
chart on pages, or the
diagram on the fuse box lid, which
fuse or fuses control that device.
Check those fuses first, but check all
the fuses before deciding that a
blown fuse is th
© 2016-2025 Copyright www.hcrv.net
