Honda CR-V manuals

Honda CR-V: DTC Troubleshooting

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / PGM-FI System / DTC Troubleshooting

READ NEXT:

 DTC P0101: MAF Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P1128, P1129, P2228, and/or P2229 are stored at the sa

 DTC P0111: IAT Sensor Circuit Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check for poor connections or loose terminals at ECT sensor 1/2

 DTC P0116: ECT Sensor 1 Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Check ECT SENSOR 1 in the

SEE MORE:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

 Remote Transmitter

LOCK - Press this button once to lock all doors and the tailgate. Some exterior lights will flash once. When you push LOCK twice within 5 seconds, you will hear a beep to verify that the doors and the tailgate are locked and the security system (if equipped) has set. You cannot l

© 2016-2026 Copyright www.hcrv.net