Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0101: MAF Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P1128, P1129, P2228, and/or P2229 are stored at the sa

 DTC P0111: IAT Sensor Circuit Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check for poor connections or loose terminals at ECT sensor 1/2

 DTC P0116: ECT Sensor 1 Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Check ECT SENSOR 1 in the

SEE MORE:

 Rear Driveshaft

Rear Driveshaft Removal 1. Raise the vehicle on a lift, and remove the rear wheels. 2. Lift up the locking tab (A) on the spindle nut (B), then remove the nut. 3. Drain the differential fluid. 4. Remove the rear driveshaft inboard joint from the rear differential assembly. 5. Disconnect the rear

 Mode Control

Use the mode control buttons to select the vents air flows from. Some air will flow from the dashboard corner vents in all modes. Air flows from the center and corner vents in the dashboard. Airflow is divided between the vents in the dashboard and the floor vents. Air flo

© 2016-2025 Copyright www.hcrv.net