Honda CR-V manuals

Honda CR-V: Driving

Honda CR-V (2006–2011) Owner's Manual / Driving

This section gives you tips on starting the engine under various conditions, and how to operate the automatic transmission. It also includes important information on parking your vehicle, the braking system, the vehicle stability assist (VSA ) system, the tire pressure monitoring system (TPMS), and facts you need if you are planning to tow a trailer or drive off-highway.

READ NEXT:

 Driving Guidelines

Your vehicle has higher ground clearance that allows you to travel over bumps, obstacles, and rough terrain. It also provides good visibility so you can anticipate problems earlier. Because

 Preparing to Drive

You still need to exercise the same care when accelerating, steering, and braking that you would in a twowheel drive vehicle. 1. Make sure all windows, mirrors, and outside lights are clean a

 Starting the Engine

1. Apply the parking brake. 2. In cold weather, turn off all electrical accessories to reduce the drain on the battery. 3. Make sure the shift lever is in Park. Press on the brake pedal. 4. W

SEE MORE:

 EVAP Canister Replacement

1. Lift the vehicle, and support it with jackstands. 2. Remove the cover (A). 3. Remove the EVAP canister baffle cover (A). 4. Disconnect the hoses (A) and the fuel subharness 6P connector (B). 5. Remove the bolts (C) and the EVAP canister bracket (D). 6. Remove the EVAP canister (A) from the E

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectly installed wheel bearing can cause one of these DTCs. 1. Turn the ignition switch OFF. 2. Check

© 2016-2025 Copyright www.hcrv.net