Honda CR-V: Driving
Honda CR-V (2006–2011) Owner's Manual / Driving
This section gives you tips on starting the engine under various conditions, and how to operate the automatic transmission. It also includes important information on parking your vehicle, the braking system, the vehicle stability assist (VSA ) system, the tire pressure monitoring system (TPMS), and facts you need if you are planning to tow a trailer or drive off-highway.
- Driving Guidelines
- Preparing to Drive
- Starting the Engine
- Automatic Transmission
- Parking
- Braking System
- Anti-lock Brakes (ABS)
- Vehicle Stability Assist (VSA ), aka Electronic Stability Control (ESC), System
- Tire Pressure Monitoring System (TPMS)
- Towing a Trailer
- Load Limits
- Checking Loads
- Towing Equipment and Accessories
- Pre-Tow Checklist
- Driving Safely With a Trailer
- Towing Your Vehicle Behind a Motorhome
- Off-Highway Driving Guidelines
READ NEXT:
Driving Guidelines
Your vehicle has higher ground
clearance that allows you to travel
over bumps, obstacles, and rough
terrain. It also provides good
visibility so you can anticipate
problems earlier.
Because
Preparing to Drive
You still need to exercise the same
care when accelerating, steering, and
braking that you would in a twowheel
drive vehicle.
1. Make sure all windows, mirrors,
and outside lights are clean a
Starting the Engine
1. Apply the parking brake.
2. In cold weather, turn off all
electrical accessories to reduce
the drain on the battery.
3. Make sure the shift lever is in
Park. Press on the brake pedal.
4. W
SEE MORE:
Valve, Spring, and Valve Seal Removal
Special Tools Required
Valve spring compressor attachment 07757-PJ1010A
Identify the valves and valve springs as they are
removed so that each item can be reinstalled in its
original position.
1. Remove the cylinder head.
2. Using an appropriate-sized socket (A) and plastic
mallet (B), lightly tap
DTC P0137: Secondary HO2S (Sensor 2)
Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed at
3,000 rpm without load (in Park or neutral) until t
© 2016-2025 Copyright www.hcrv.net
