Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC 11-1x/4x ("x" can be 0 thru 9 or A thru F) : Open or Increased Resistance in Driver's Airbag First/Second Inflator

DTC 11-1x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Airbag First Inflator DTC 11-4x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Airbag

 DTC 21-1x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Seat Belt Tensioner

DTC 21-1x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Seat Belt Tensioner Special Tools Required  SRS inflator simulator 07SAZ-TB4011A  SRS simulator lead

 DTC 22-3x ("x" can be 0 thru 9 or A thru F): Short to Another Wire or Decreased Resistance in Front Passenger's Seat Belt Tensioner

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead K 070AZ-SNAA200 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase th

SEE MORE:

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectly installed wheel bearing can cause one of these DTCs. 1. Turn the ignition switch OFF. 2. Check

 Carbon Monoxide Hazard

Your vehicle’s exhaust contains carbon monoxide gas. Carbon monoxide should not enter the vehicle in normal driving if you maintain your vehicle properly and follow the information on this page. Have the exhaust system inspected for leaks whenever: The vehicle is raised for an

© 2016-2026 Copyright www.hcrv.net