Honda CR-V: Restraints

READ NEXT:

 Seat Belts

Component Location Index REAR CENTER SEAT BELT REAR CENTER SEAT BELT BUCKLE and LEFT REAR SEAT BELT BUCKLE REAR SEAT BELT FRONT SEAT BELT FRONT SEAT BELT BUCKLES RIGHT FRONT SEAT BELT LOWER A

 SRS (Supplemental Restraint System)

Component Location Index SRS INDICATOR SIDE AIRBAG CUTOFF INDICATOR MEMORY ERASE SIGNAL (MES) CONNECTOR (2P) (YELLOW) CABLE REEL PASSENGER'S AIRBAG CUTOFF INDICATOR FRONT PASSENGER'S AIRB

 Precautions and Procedures

General Precautions Please read the following precautions carefully before servicing the airbag system. Observe the instructions described in this manual, or the airbags could accidentally deploy and

SEE MORE:

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectly installed wheel bearing can cause one of these DTCs. 1. Turn the ignition switch OFF. 2. Check

 Intermediate Shaft

Intermediate Shaft Removal 1. Drain the automatic transmission fluid. Reinstall the drain plug with a new washer. 2. Remove the right driveshaft. 3. Remove the flange bolt (A) and two dowel bolts (B). 4. Remove the intermediate shaft (A) from the differential. Hold the intermediate shaft horizon

© 2016-2026 Copyright www.hcrv.net