Honda CR-V: HVAC (Heating, Ventilation, and Air Conditioning)
Honda CR-V (2006–2011) Service Manual / HVAC (Heating, Ventilation, and Air Conditioning)
Special Tools
-
Backprobe set
Component Location Index
- SERVICE VALVE (HIGH-PRESSURE SIDE)
- SERVICE VALVE (LOW-PRESSURE SIDE)
- EVAPORATOR CORE (Located-in the heater unit)
- RECEIVER/DRYER DESICCANT
- Replacement
- A/C CONDENSER
- Replacement
- Clutch Check
- Clutch Overhaul
- Thermal Protector Check
- Thermal Protector Replacement
- Relief Valve Replacement
- UNDER-HOOD FUSE/RELAY BOX
- RADIATOR FAN RELAY
- A/C CONDENSER FAN RELAY
- FAN CONTROL RELAY
- BLOWER MOTOR RELAY
- A/C COMPRESSOR CLUTCH RE
- A/C DIODE A
- A/C DIODE B
- A/C PRESSURE SENSOR
- A/C CONDENSER FAN
- RADIATOR FAN
- HEATER UNIT/CORE
- EVAPORATOR CORE (Located-in the heater unit)
- BLOWER UNIT
- RECIRCULATION CONTROL MOTOR
- DUST AND POLLEN FILTER
- MODE CONTROL MOTOR
- HVAC CONTROL UNIT
- POWER TRANSISTOR
- EVAPORATOR TEMPERATURE SENSOR
- AIR MIX CONTROL MOTOR
- A/C Service Tips and Precautions
- System Description
- DTC Troubleshooting
- Recirculation Control Motor Circuit Troubleshooting
- Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting
- A/C Condenser Fan High Speed Circuit Troubleshooting
- A/C Signal Circuit Troubleshooting
- Blower Unit Removal/Installation
- Evaporator Core Replacement
- Heater Unit/Core Replacement
- A/C Compressor Replacement
- Receiver/Dryer Desiccant Replacement
READ NEXT:
A/C Service Tips and Precautions
WARNING
Compressed air mixed with the R-134a forms a
combustible vapor.
The vapor can burn or explode causing serious
injury.
Never use compressed air to pressure test
R-134a service equipment
System Description
The air conditioning system removes heat from the passenger compartment by
transferring heat from the ambient air
to the evaporator. The evaporator cools the air with the refrigerant that is
circula
DTC Troubleshooting
DTC indicator 1: An Open in the Air Mix
Control Motor Circuit
1. Start the engine.
2. Turn on the A/C, then set the temperature control
dial to Max Hot.
3. Turn the ignition switch OFF and then ON (
SEE MORE:
Symptom Troubleshooting
Power Door Locks/Keyless
1. Check for B-CAN DTCs. If any B-CAN DTCs are indicated, troubleshoot and
resolve them first.
2. If the door lock system and the keyless operation. does not work, troubleshoot
the door locks first.
NOTE: The system does not function when the ignition switch is ON (II).
Overview of Contents
Contents
A convenient reference to the
sections in this manual.
Your Vehicle at a Glance
A quick reference to the main
controls in your vehicle.
Driver and Passenger Safety
Important information about the
proper use and care of your vehicle’s
seat belts, an overview of the
supplemen
© 2016-2025 Copyright www.hcrv.net
