Honda CR-V: HVAC (Heating, Ventilation, and Air Conditioning)
Honda CR-V (2006–2011) Service Manual / HVAC (Heating, Ventilation, and Air Conditioning)
Special Tools
-
Backprobe set
Component Location Index
- SERVICE VALVE (HIGH-PRESSURE SIDE)
- SERVICE VALVE (LOW-PRESSURE SIDE)
- EVAPORATOR CORE (Located-in the heater unit)
- RECEIVER/DRYER DESICCANT
- Replacement
- A/C CONDENSER
- Replacement
- Clutch Check
- Clutch Overhaul
- Thermal Protector Check
- Thermal Protector Replacement
- Relief Valve Replacement
- UNDER-HOOD FUSE/RELAY BOX
- RADIATOR FAN RELAY
- A/C CONDENSER FAN RELAY
- FAN CONTROL RELAY
- BLOWER MOTOR RELAY
- A/C COMPRESSOR CLUTCH RE
- A/C DIODE A
- A/C DIODE B
- A/C PRESSURE SENSOR
- A/C CONDENSER FAN
- RADIATOR FAN
- HEATER UNIT/CORE
- EVAPORATOR CORE (Located-in the heater unit)
- BLOWER UNIT
- RECIRCULATION CONTROL MOTOR
- DUST AND POLLEN FILTER
- MODE CONTROL MOTOR
- HVAC CONTROL UNIT
- POWER TRANSISTOR
- EVAPORATOR TEMPERATURE SENSOR
- AIR MIX CONTROL MOTOR
- A/C Service Tips and Precautions
- System Description
- DTC Troubleshooting
- Recirculation Control Motor Circuit Troubleshooting
- Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting
- A/C Condenser Fan High Speed Circuit Troubleshooting
- A/C Signal Circuit Troubleshooting
- Blower Unit Removal/Installation
- Evaporator Core Replacement
- Heater Unit/Core Replacement
- A/C Compressor Replacement
- Receiver/Dryer Desiccant Replacement
READ NEXT:
A/C Service Tips and Precautions
WARNING
Compressed air mixed with the R-134a forms a
combustible vapor.
The vapor can burn or explode causing serious
injury.
Never use compressed air to pressure test
R-134a service equipment
System Description
The air conditioning system removes heat from the passenger compartment by
transferring heat from the ambient air
to the evaporator. The evaporator cools the air with the refrigerant that is
circula
DTC Troubleshooting
DTC indicator 1: An Open in the Air Mix
Control Motor Circuit
1. Start the engine.
2. Turn on the A/C, then set the temperature control
dial to Max Hot.
3. Turn the ignition switch OFF and then ON (
SEE MORE:
Component Replacement/Inspection After
Deployment
NOTE:
Before doing any SRS repairs, use the HDS SRS
menu method to check for DTCs; refer to the DTC
Troubleshooting Index for the less obvious deployed
parts (seat belt tensioners, front impact sensors, side
airbag sensors, etc.)
Do not replace the ODS unit unless it is physically
damaged or
XM radio display is blank and no station
information is displayed
1. Disconnect audio disc changer 13P connector.
2. Turn the ignition switch to ACC (I).
3. Operate the XM radio, and check the display.
Is XM information displayed? YES-Replace the audio disc changer.
NO-Go to step 4.
4. Check the No. 34 (7.5 A) fuse in the under-dash
fuse/relay box and the No.
© 2016-2026 Copyright www.hcrv.net
