Honda CR-V: SRS (Supplemental Restraint System)
Honda CR-V (2006–2011) Service Manual / Restraints / SRS (Supplemental Restraint System)
Component Location Index
- SRS INDICATOR
- SIDE AIRBAG CUTOFF INDICATOR
- MEMORY ERASE SIGNAL (MES) CONNECTOR (2P) (YELLOW)
- CABLE REEL
- PASSENGER'S AIRBAG CUTOFF INDICATOR
- FRONT PASSENGER'S AIRBAG
- DRIVER'S AIRBAG
- OPDS SENSOR/SEAT-BACK
- FRONT PASSENGER'S SIDE AIRBAG
- RIGHT SIDE IMPACT SENSOR (FIRST)
- FRONT PASSENGER'S SEAT BELT TENSIONER
- ODS UNIT
- FRONT PASSENGER'S SEAT BELT BUCKLE TENSIONER
- DRIVER'S SEAT BELT BUCKLE TENSIONER
- DRIVER'S SEAT BELT TENSIONER
- LEFT SIDE IMPACT SENSOR (FIRST)
- DRIVER'S SEAT POSITION SENSOR
- DRIVER'S SIDE AIRBAG
- SRS UNIT
- RIGHT FRONT IMPACT SENSOR
- LEFT SIDE CURTAIN AIR BAG
- RIGHT SIDE CURTAIN AIRBAG
- LEFT FRONT IMPACT SENSOR
- LEFT SIDE IMPACT SENSOR (SECOND)
- RIGHT SIDE IMPACT SENSOR (SECOND)
- Precautions and Procedures
- General Troubleshooting Information
- System Description
- DTC Troubleshooting
- Symptom Troubleshooting
- Component Replacement/Inspection After Deployment
- Driver's Airbag Replacement
- Front Passenger's Airbag Replacement
- Side Airbag Replacement
- Airbag and Tensioner Disposal
- Cable Reel Replacement
READ NEXT:
Precautions and Procedures
General Precautions
Please read the following precautions carefully before
servicing the airbag system. Observe the instructions
described in this manual, or the airbags could
accidentally deploy and
General Troubleshooting Information
DTC (Diagnostic Trouble Codes)
The self-diagnostic function of the SRS system allows it
to locate the causes of system problems and then store
this information in memory. For easier troubleshooting,
t
System Description
SRS Components
Airbags
The SRS is a safety device which, when used with the seat belt, is designed
to help protect the driver and front
passenger in a frontal impact exceeding a certain set limit. Th
SEE MORE:
Cylinder Head Installation
1. Install a new coolant separator in the engine block
whenever the engine block is replaced.
2. Clean the cylinder head and block surface.
3. Install the new cylinder head gasket (A) and dowel
pins (B) on the engine block. Always use a new
cylinder head gasket.
Set the crankshaft to top dead cen
Cowl Cover Replacement
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the cowl cover and body.
Use the appropriate tool from the KTC trim tool set to
avoid da
© 2016-2025 Copyright www.hcrv.net
