Honda CR-V: SRS (Supplemental Restraint System)
Honda CR-V (2006–2011) Service Manual / Restraints / SRS (Supplemental Restraint System)
Component Location Index
- SRS INDICATOR
- SIDE AIRBAG CUTOFF INDICATOR
- MEMORY ERASE SIGNAL (MES) CONNECTOR (2P) (YELLOW)
- CABLE REEL
- PASSENGER'S AIRBAG CUTOFF INDICATOR
- FRONT PASSENGER'S AIRBAG
- DRIVER'S AIRBAG
- OPDS SENSOR/SEAT-BACK
- FRONT PASSENGER'S SIDE AIRBAG
- RIGHT SIDE IMPACT SENSOR (FIRST)
- FRONT PASSENGER'S SEAT BELT TENSIONER
- ODS UNIT
- FRONT PASSENGER'S SEAT BELT BUCKLE TENSIONER
- DRIVER'S SEAT BELT BUCKLE TENSIONER
- DRIVER'S SEAT BELT TENSIONER
- LEFT SIDE IMPACT SENSOR (FIRST)
- DRIVER'S SEAT POSITION SENSOR
- DRIVER'S SIDE AIRBAG
- SRS UNIT
- RIGHT FRONT IMPACT SENSOR
- LEFT SIDE CURTAIN AIR BAG
- RIGHT SIDE CURTAIN AIRBAG
- LEFT FRONT IMPACT SENSOR
- LEFT SIDE IMPACT SENSOR (SECOND)
- RIGHT SIDE IMPACT SENSOR (SECOND)
- Precautions and Procedures
- General Troubleshooting Information
- System Description
- DTC Troubleshooting
- Symptom Troubleshooting
- Component Replacement/Inspection After Deployment
- Driver's Airbag Replacement
- Front Passenger's Airbag Replacement
- Side Airbag Replacement
- Airbag and Tensioner Disposal
- Cable Reel Replacement
READ NEXT:
Precautions and Procedures
General Precautions
Please read the following precautions carefully before
servicing the airbag system. Observe the instructions
described in this manual, or the airbags could
accidentally deploy and
General Troubleshooting Information
DTC (Diagnostic Trouble Codes)
The self-diagnostic function of the SRS system allows it
to locate the causes of system problems and then store
this information in memory. For easier troubleshooting,
t
System Description
SRS Components
Airbags
The SRS is a safety device which, when used with the seat belt, is designed
to help protect the driver and front
passenger in a frontal impact exceeding a certain set limit. Th
SEE MORE:
Dual Pump System Function Test
Starting and accelerating in forward gears
(4WD mode)
NOTE: Do not test repeatedly or the fluid will overheat.
1. Lift up the vehicle so all four wheels are off the ground.
2. Make a mark (A) on either No.1 or No.2 propeller
shaft (B).
3. Start the engine, and let it run until it warms up (the
ra
DTC P0962: Problem in A/T Clutch Pressure
Control Solenoid Valve A Circuit
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review General
Troubleshooting Information (see page 14-4).
This code is caused by an electrical circuit problem
and cannot be caused by a mechanical problem in the
transmission.
1. Clear the DTC with the HD
© 2016-2025 Copyright www.hcrv.net
