Honda CR-V: Engine Electrical
Honda CR-V (2006–2011) Service Manual / Engine Electrical
- Starting System
- Ignition System
- Charging System
- Charging System Indicator Circuit Troubleshooting
- Alternator and Regulator Circuit Troubleshooting
- Drive Belt Inspection
- Alternator Removal and Installation
- Cruise Control
READ NEXT:
Starting System
Component Location Index
STARTER CUT RELAY
UNDER-DASH
FUSE/RELAY BOX
STARTER
Starter Circuit Troubleshooting
Performance Test
Removal and Installation
Overhaul
Ignition System
Component Location Index
SPARK PLUG
Inspection
IGNITION COIL
Ignition Timing Inspection
Removal/Installation
Circuit Diagram
Ignition Timing Inspection
1. Conne
Charging System
Component Location Index
CHARGING SYSTEM INDICATOR
(In the gauge control module)
UNDER-HOOD FUSE/RELAY BOX
(Has built-in ELECTRICAL LOAD
DETECTOR [ELD] UNIT)
BATTERY
ALTERNATOR
DRI
SEE MORE:
Side Windshield Trim Replacement
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Take care not to damage the windshield,
Do not use any metallic tools to remove the roof
molding, or you may chip
Seat Heaters
If equipped
Both front seats are equipped with
seat heaters. The passenger seat
only has heaters in the seat bottom
because of the side airbag cutoff
system.
The ignition switch must be in the
ON (II) position to use the heaters.
Push the top of the switch, HI, to
rapidly heat
© 2016-2025 Copyright www.hcrv.net
