Honda CR-V: Engine Electrical
Honda CR-V (2006–2011) Service Manual / Engine Electrical
- Starting System
- Ignition System
- Charging System
- Charging System Indicator Circuit Troubleshooting
- Alternator and Regulator Circuit Troubleshooting
- Drive Belt Inspection
- Alternator Removal and Installation
- Cruise Control
READ NEXT:
Starting System
Component Location Index
STARTER CUT RELAY
UNDER-DASH
FUSE/RELAY BOX
STARTER
Starter Circuit Troubleshooting
Performance Test
Removal and Installation
Overhaul
Ignition System
Component Location Index
SPARK PLUG
Inspection
IGNITION COIL
Ignition Timing Inspection
Removal/Installation
Circuit Diagram
Ignition Timing Inspection
1. Conne
Charging System
Component Location Index
CHARGING SYSTEM INDICATOR
(In the gauge control module)
UNDER-HOOD FUSE/RELAY BOX
(Has built-in ELECTRICAL LOAD
DETECTOR [ELD] UNIT)
BATTERY
ALTERNATOR
DRI
SEE MORE:
Recirculation Control Motor
Circuit Troubleshooting
1. Check the No. 36 (10 A) fuse in the under-dash fuse/
relay box.
Is the fuse OK?
YES-Go to step 2.
NO-Replace the fuse, and recheck. If the fuse blows again, check for a short in
the No. 36 (10 A) fuse circuit.
2. Disconnect the recirculation control motor 7P
connector.
3. Turn the ignition s
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the same time as DTC P0101, troubleshoot those
DTCs first, then recheck for DTC P0101.
1. Check for poor
© 2016-2025 Copyright www.hcrv.net
