Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Transmission Mount Replacement

1. Loosen the upper torque rod mounting bolt (A). 2. Remove the air cleaner housing assembly. 3. Remove the powertrain control module (PCM) cover, then remove the three bolts securing the PCM. 4. Remove the PCM bracket. 5. Support the transmission with a jack and wood block under the transmissio

 Replacing Tires andWheels

Replace your tires with radial tires of the same size, load range, speed rating, and maximum cold tire pressure rating (as shown on the tire’s sidewall). Mixing radial and bias-ply tires on your vehicle can reduce braking ability, traction, and steering accuracy. Using tires of a di

© 2016-2025 Copyright www.hcrv.net