Honda CR-V manuals

Honda CR-V: Driveline/Axle

Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 Wipers/Washers

Component Location Index WINDSHIELD WIPER BLADES WIPER/WASHER SWITCH WINDSHIELD WIPER ARMS and LINK WINDSHIELD WIPER MOTOR UNDER-DASH FUSE/RELAY BOX UNDER-HOOD FUSE/RELAY BOX INTERMITTENT WIPER RELAY CIRCUIT (Built into the MICU) REAR WIPER BLADE REAR WIPER ARM REAR WINDOW WIPER MOT

 Transmission Housing

Housing and Shaft Assembly Removal NOTE: The illustration shows the 4WD transmission; the 2WD does not have the transfer mechanism. 1. Remove the ATF feed pipe (A) from the idler gear shaft, and the ATF lubrication pipe (B) from the transmission housing. 2. Remove the shift solenoid valve cover (

© 2016-2025 Copyright www.hcrv.net