Honda CR-V: Driveline/Axle

Special Tools

Honda CR-V. Driveline/Axle

Honda CR-V. Driveline/Axle

  1. Oil Seal Driver
  2. Attachment, 52 x 55 mm
  3. Half Shaft Base
  4. Threaded Adapter, 24 x 1.5 mm
  5. Threaded Adapter, 26 x 1.5 mm
  6. Attachment, 35 mm I.D.
  7. Driver
  8. Inner Handle, 30 mm
  9. Oil Seal Driver

Component Location Index

Honda CR-V. Driveline/Axle

READ NEXT:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends on

SEE MORE:

 SRS (Supplemental Restraint System)

Component Location Index SRS INDICATOR SIDE AIRBAG CUTOFF INDICATOR MEMORY ERASE SIGNAL (MES) CONNECTOR (2P) (YELLOW) CABLE REEL PASSENGER'S AIRBAG CUTOFF INDICATOR FRONT PASSENGER'S AIRBAG DRIVER'S AIRBAG OPDS SENSOR/SEAT-BACK FRONT PASSENGER'S SIDE AIRBAG RIGHT SIDE IMPACT SENSOR

 To Play a PC Card

You operate the PC card player with the same controls used for the radio and the disc player. To load or play a card, the ignition switch must be in the ACCESSORY (I) or ON (II) position. The PC card player reads and plays cards in MP3 or WMA formats. Depending on the format, the scree

© 2016-2025 Copyright www.hcrv.net