Honda CR-V: Driveline/Axle
Honda CR-V (2006–2011) Service Manual / Transaxle / Driveline/Axle
Special Tools
- Oil Seal Driver
- Attachment, 52 x 55 mm
- Half Shaft Base
- Threaded Adapter, 24 x 1.5 mm
- Threaded Adapter, 26 x 1.5 mm
- Attachment, 35 mm I.D.
- Driver
- Inner Handle, 30 mm
- Oil Seal Driver
Component Location Index
- BOOT BAND
- Removal
- Installation
- INTERMEDIATE SHAFT
- Removal
- Disassembly
- Reassembly
- Installation
- FRONT DRIVES HAFT
- Inspection
- Removal
- Disassembly
- Reassembly
- Installation
- PROPELLER SHAFT
- Inspection
- Removal
- Installation
- REAR DRIVESHAFT
- Inspection
- Removal
- Disassembly
- Reassembly
- Installation
- Driveshaft Inspection
- Front Driveshaft Disassembly
- Boot Band Installation
- Front Driveshaft Reassembly
- Front Driveshaft Installation
- Intermediate Shaft
- Rear Driveshaft
- Propeller Shaft
READ NEXT:
Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot
(B) on the driveshaft (C) for cracks, damage, leaking
grease, and loose boot bands (D). If any damage is
found, replace the boot and boot bands.
2.
Front Driveshaft Disassembly
Special Tools Required
Threaded adapter, 26 x 1.5 mm 07XAC-001030A
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint.
2. Remov
Boot Band Installation
Special Tools Required
Boot band tool, KD-3191 or equivalent, commercially
available
Boot band pliers, Kent-Moore J-35910 or equivalent,
commercially available
Double Loop Type
1. Fit the boot ends on
SEE MORE:
Camshaft Inspection
NOTE: Do not rotate the camshaft during inspection.
1. Remove the rocker arm assembly.
2. Put the rocker shaft holders, camshaft, and
camshaft holders on the cylinder head, then tighten
the bolts, in sequence, to the specified torque.
NOTE: If the engine does not have bolt 21, skip it
and continu
Heater Unit/Core
Replacement
SRS components are located in this area. Review the
SRS component locations, and the
precautions and procedures before
doing repairs or service.
1. Make sure you have anti-theft codes for the audio
system and the navigation system (if equipped).
2. Make sure the ignition is OFF, then disconnect the
© 2016-2025 Copyright www.hcrv.net
