Honda CR-V: Conventional Brake Components

Honda CR-V (2006–2011) Service Manual / Brakes / Conventional Brake Components

Special Tools

Honda CR-V. Conventional Brake Components

Honda CR-V. Conventional Brake Components

  1. Brake Caliper Piston  Compresor

Component Location Index

Honda CR-V. Conventional Brake Components

READ NEXT:

 Brake System

Brake System Inspection and Test Inspect the brake system components listed. Repair or replace any parts that are leaking or damaged. Component Inspections Brake System Test Brake pedal sinks/fades

 Front Brake

Front Brake Pad Inspection and Replacement Special Tools Required Brake caliper piston compressor 07 AAE-SEPA 101 CAUTION Frequent inhalation of brake pad dust, regardless of material composition, cou

 Master Cylinder

Master Cylinder Replacement NOTICE Do not spill brake flu id on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water. Be careful not to dam

SEE MORE:

 DTC 31-3x ("x" can be 0 thru 9 or A thru F): Short to Another Wire or Decreased Resistance in Driver's Side Airbag Inflator

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead L 070AZ-SNAA300 SRS short canceller 070AZ-SAA0100 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and check t

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and the back cover. You can quickly find the first page of each section without looking through a full ta

© 2016-2025 Copyright www.hcrv.net