Honda CR-V manuals

Honda CR-V: Engine Cooling

Honda CR-V (2006–2011) Service Manual / Engine Cooling

READ NEXT:

 Cooling System

Component Location Index COOLANT SEPARATOR EXHAUST GAS RECIRCULATION (EGR) PASSAGE THERMOSTAT RADIATOR ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2 RADIATOR FAN ASSEMBLY A/C COND

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi)

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the in

SEE MORE:

 Sunvisor Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. Take care not to scra

 MICU Input Test

NOTE: The MICU turns on the headlights (high beams) in a dim mode for the daytime running lights under the following conditions: The ignition switch is ON (II) The headlight switch is OFF The parking brake is released (parking brake switch OFF) If the vehicle is equipped with an opti

© 2016-2026 Copyright www.hcrv.net